EasyManuals Logo

Honeywell Home T6 Quick Start Guide

Honeywell Home T6
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
The T6RWP Smart Thermostat wireless thermostat comes unbound from the factory and binding is required during
installation (see previous page).
The binding operation described below is only required if:
The T6RWP thermostat or Receiver box is replaced.
The T6RWP thermostat or Receiver box has incorrect or no binding data stored.
- Thermostat will indicate the Alert message: NO RECEIVER BOX BINDING
- Receiver box status LED remains green blinking (no communication from thermostat)
- Receiver box status LED does not light up (not bound).
1. Put the Receiver box into binding mode by pressing the Heat button for 3 sec.
- The first LED will flash amber
2. Enable binding on the thermostat:
- Enter the advanced menu by pressing the button for 5 sec.
- Navigate to BINDING
- Select BIND and the signal will be sent
3. When binding is successful:
- Thermostat will show SUCCESS
- First Receiver box status LED will show green
Note: When the Receiver box has been bound before first press with a small pin
the pinhole for approximately 3 seconds to reset the binding. All LED’s will
flash amber for a moment.
When binding is NOT successful:
- Thermostat will show FAILED
- Receiver box will exit binding after 3 min.
RF communication might be too far or is blocked due to wrong location of the
Thermostat or Receiver box. Try to move closer or re-locate and re-bind again.
7
After power up, SETUP is displayed on the thermostat’s screen.
Touch
to begin.
setup
Select language.
Set clock format, time
and date.
Touch
to finalise setup.
(
to setup using the
Honeywell Home App is
currently unsupported)

Other manuals for Honeywell Home T6

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell Home T6 and is the answer not in the manual?

Honeywell Home T6 Specifications

General IconGeneral
ModelHoneywell Home T6
CategoryThermostat
Wi-Fi ConnectivityYes
DisplayTouchscreen
Operating ModesHeat, Cool, Auto, Off
Humidity ControlNo
Warranty1-year limited warranty
CompatibilityWorks with most HVAC systems
ProgrammableYes
Power SourceBattery
FeaturesGeofencing
Dimensions4.06 x 4.06 x 1.06 inches
Temperature Range40°F to 90°F
Remote ControlYes (via app)
Energy Saving FeaturesGeofencing

Related product manuals