6 - 17
Code 128 Function Code Transmit
By default, Code 128 function codes are not transmitted with Code 128 bar
code data. However, if you wish to transmit Code 128 function codes with the
bar code data, scan the Function Codes On bar code, below.
Telepen
<Default All Telepen Settings>
Telepen
Telepen Output
Using AIM Telepen Output, the image scanner reads symbols with start/stop
pattern 1 and decodes them as standard full ASCII (start/stop pattern 1). When
Original Telepen Output is selected, the image scanner reads symbols with
start/stop pattern 1 and decodes them as compressed numeric with optional full
ASCII (start/stop pattern 2).
Default = AIM Telepen Output.
* Function Codes Off
Function Codes On
Original Telepen Output
* AIM Telepen Output
To Next Page
Loading...
