Honeywell 2020-5

6 - 18
Telepen Message Length
Scan the bar codes below to change the message length. Refer to Message
Length on page 6-2 for additional information. Minimum and Maximum
lengths = 1-60. Minimum Default = 1, Maximum Default = 60.
UPC A
<Default All UPC A Settings>
UPC A
UPC A Check Digit
This selection allows you to specify whether the check digit should be transmit-
ted at the end of the scanned data or not. Default = On.
Minimum Message Length
Maximum Message Length
* On
Off
* On
Off