Chapter 10 Program Example
40 Pnet I/F Module 2MLL-PSRA, 2MLL-PMEA, 2MLL-PMEB User’s Guide R220
Honeywell January 2019
[Figure 10.3.20] Write
After Write is finished, the operation is by applicable high-speed link enabled. Select the [Online]-
[Communication module setting]-[Enable Link] (High-speed, P2P). And Link Enable window is displayed as
shown below. Select the applicable High-speed link number and then select ‘Write’ to set.
[Figure 10.3.21] Link Enable (High-speed link, P2P)
To Next Page
Loading...
