To Next Page

To Previous Page

5 - 6

User Specified Intercharacter Delay

An intercharacter delay of up to 495 milliseconds may be placed after the

transmission of a particular character of scanned data. Scan the Delay Length

bar code below, then scan the number of milliseconds and the SAVE bar code

using the Programming Chart inside the back cover of this manual.

Next, scan the Character to Trigger Delay bar code, then the 2-digit hex value

for the ASCII character that will trigger the delay ASCII Conversion Chart (Code

Page 1252), page A-3.

To remove this delay, scan the Delay Length bar code, and set the number of

steps to 0. Scan the SAVE bar code using the Programming Chart inside the

back cover of this manual.

Interfunction Delay

An interfunction delay of up to 495 milliseconds may be placed between the

transmission of each segment of the message string. Scan the Interfunction

Delay bar code below, then scan the number of milliseconds and the SAVE bar

code using the Programming Chart inside the back cover of this manual.

To remove this delay, scan the Interfunction Delay bar code, then set the

number of steps to 0. Scan the SAVE bar code using the Programming Chart

inside the back cover of this manual.

Delay Length

Character to Trigger Delay

Interfunction Delays

Prefix Scanned Data Suffix

1 2345STX HT CR LF

Interfunction Delay

Honeywell 5110 User Manual

Other manuals for Honeywell 5110