1. To open the safe, turn handle counterclockwise (to the left) until it stops. The handle should be in
the vertical position. Always do this before entering the code. (Figure 1)
2. Enter the preset factory code “168” followed by the # key.
3. If the code is entered correctly, the keypad will beep twice, a green LED will light up, and you will
hear a click, indicating that the door is now unlocked. Turn handle clockwise (to the right) to open.
(Figure 2 & 3)
Note: You will have approximately 5 seconds to open the safe before it re-locks, at which point you
will need to reenter the code to open the safe. If the code is entered incorrectly, the safe will begin
beeping and the yellow LED light will flash continuously. Repeat Step 2.
UNLOCK & OPEN YOUR NEW SAFE
Figure 1 Figure 2 Figure 3
3
The battery must be installed before using your safe. The battery compartment is located at the
bottom of the digital keypad.
1. Open the battery cover under the keypad housing. (Figure 1)
2. Pull out the battery connection wire and attach the 9 volt battery (not included). (Figure 2)
3. Insert the connected 9 volt battery into the housing and close the battery cover. (Figure 3)
INSTALL BATTERY
Note: If the red LED is on, it is an indicator that the batteries are weak and must be changed
immediately. The user codes will not be erased if the battery is weak or removed. To replace
the battery please follow STEPS 1 - 3.
If your battery is completely dead and you cannot open the safe by using the digital keypad,
use the override access key to open safe. The use of non-alkaline or rechargeable batteries
is NOT RECOMMENDED.
Figure 1 Figure 2 Figure 3
To Next Page
Loading...
Need help?
General
