5
SECONDARY USER CODE: PROGRAMMING & TESTING
1. With the safe in the closed and locked position, turn the handle all the way to the left.
It should be in the vertical position. Enter the preset factory code for the Secondary User
“12345678” followed by the # key. (Figure 1) Turn the handle clockwise (to the right) to
unlock and and open the safe.
2. With the safe door open, press the “0” key twice.
3. Locate and press the red RESET button on the inside edge of the safe door. (Figure 2)
You will hear two beeps and a Yellow LED light will turn on. (Figure 3)
4. Enter a new 18 digit Secondary User Code of your choice, followed by the * key. Your Secondary
User Code is now set. Close the safe door and test the code to make sure it is working properly.
5. Make sure the handle is turned all the way to the left. It should be in the vertical position. (Figure 4)
6. Enter your Secondary User Code followed by the # key.
· If the code is entered correctly, the keypad will beep twice, the green LED light will turn on and
you will hear a click, indicating that the safe is now unlocked. Turn the handle clockwise (to the
right) to open. (Figure 5 & 6)
Note: You will have approximately 5 seconds to open the safe before it re-locks, at which point you
will need to reenter the code to open the safe.
· If the code is entered incorrectly, the safe will begin beeping and the yellow LED light will flash
continuously. Repeat Step 6.
If you continue to have trouble opening the safe, use the override keys to unlock the safe and reset
the Secondary User Code beginning with Step 2.
Figure 2
Figure 1
Figure 4 Figure 5 Figure 6
Figure 3
To Next Page
Loading...
Need help?
General
