Honeywell ADEMCO LYNXR - Adjusting the Volume; To Adjust Message Playback;System Announcement Volume; To Mute System Announcements; To Restore Announcement Sounding

– 24 –
86(5)81&7,216
0HVVDJH5HFRUGLQJ3OD\EDFN9ROXPH&RQWURO

$GMXVWLQJWKH9ROXPH
The volume level of message playback, system announcements, and status beeps can be changed. You
can also mute system announcements if desired. See NOTE below if using a wireless keypad.
To adjust message playback/system announcement volume:
)81&7,21  92/80(  >@ RU >@

†
[3] = increases volume one level, [6] = decreases volume one level.
Repeat the key sequence until the desired volume level is achieved.
To mute system announcements:
)81&7,21  92/80(  2))
When muted, no system announcements will be made. Recorded messages will be announced, though,
when
3/$<
is pressed.
To restore announcement sounding:
)81&7,21  92/80(  >@ RU >@
Volume level will be restored to the level that was selected prior to muting the sound.
NOTE:
If a wireless keypad (5827) has been installed and is programmed for quick arming, it cannot be used to
activate message playback or adjust the volume. In this case, you must use the master keypad to perform
these functions.