Honeywell ADEMCO LYNXR - Remote Phone Control Commands

– 34 –
86(5)81&7,216
5HPRWH3KRQH&RQWURO)HDWXUH
Enter:
ZLWKLQ HLJKW VHFRQGV
<RXU XVHU FRGH
Upon entering remote phone control mode the Lynx will announce “System, enter code”.
Remote Phone Control Commands
To remotely disarm system:
 >@
<RXU XVHU FRGH
To remotely arm in AWAY mode:
 >@
<RXU XVHU FRGH
To remotely arm in STAY mode:
 >@
<RXU XVHU FRGH
To remotely arm in AWAY or STAY mode with no delay:
 >@ RU >@  >@
<RXU XVHU FRGH
To remotely activate X-10 devices 1-6:
>@  >@  GHYLFH QR
To remotely activate X-10 devices 7 & 8:
 >@  >@  GHYLFH QR
<RXU XVHU FRGH
To remotely deactivate X-10 devices 1-6:
>@  >@  GHYLFH QR
To remotely deactivate X-10 devices 7 & 8:
 >@  >@  GHYLFH QR
<RXU XVHU FRGH
To remotely Bypass zones:
 >@  ]RQH QR
<RXU XVHU FRGH
To remotely activate Forced Bypass:
 >@  >@
<RXU XVHU FRGH
To remotely check system status:
[*]
To end remote phone session:
+DQJ 8S RU  >@
<RXU XVHU FRGH
NOTES
: (1) Check with your installer to see if the Forced Bypass mode has been enabled.
(2) When bypassing zones, make sure a confirmation beep sounds for each zone that has been bypassed.