To Next PageTo Next Page
Need help?Do you have a question about the Honeywell C7061 A and is the answer not in the manual?
General| Brand | Honeywell |
|---|---|
| Model | C7061 A |
| Category | Security Sensors |
| Language | English |
Explains the C7061A1020 and C7061F1003 detector models, their differences, and mounting.
Lists key features like oscillating shutter, field replaceable parts, parallel wiring, and enclosure standards.
Details how to order the detector, including model numbers and separately orderable items.
Provides detailed specifications including models, operating conditions, electrical and physical specifications, mounting, and wiring.
Details EC Directives for C7061A/F and specific compliance for C7061F regarding explosive atmospheres.
Lists additional certifications and approvals for the C7061A model from UL, CSA, and FM.
Lists common replacement parts and accessories applicable to both C7061A and C7061F models.
Guides on determining the best location considering temperature, vibration, clearance, and potential radiation sources.
Details sighting angle, minimizing screening effects, and pilot/burner flame requirements for single burners.
Covers flame discrimination, multi-burner placement, and parallel detector use for reliable operation.
Explains how smoke, mist, and dust affect UV signals and methods to reduce their impact.
Covers preparing the sight pipe hole, installing the pipe, reducers, ventilation, and accessory mounts.
Provides instructions for mounting the detector, ensuring correct orientation and alignment for optimal performance.
Highlights critical precautions for wiring, including avoiding shorts, using correct wire types, and conduit requirements.
Explains how to connect two detectors in parallel for improved reliability and lists limitations.
Guides on adjusting the detector's sighting position for optimum flame signal measurement.
Tests to ensure ignition spark does not falsely trigger the flame relay.
Warns against using artificial light sources for testing; recommends flame failure tests.
Instructs to weld the sight pipe in its final position after adjustments are complete.
Emphasizes performing all checkout procedures before system operation.
Outlines initial checks for voltage, wiring defects, and detector temperature.
Provides steps for low or zero flame signal readings, including detector adjustment and replacement.
Details the procedure for safely removing the C7061A and C7061F detectors from the sight pipe.
Lists component replacement steps for resolving a zero meter reading issue.
Covers cleaning the viewing window and keeping the flame detection system adjusted.
Step-by-step guide for safely replacing the UV sensor tube in the detector.
Instructions for replacing the coil and shutter assembly, including wiring connections.
Details the procedure for replacing the quartz viewing window or focusing lens for C7061A and C7061F.
