Need help?Do you have a question about the Honeywell ControlEdge 900H01-0202 and is the answer not in the manual?
General| Brand | Honeywell |
|---|---|
| Model | ControlEdge 900H01-0202 |
| Category | Controller |
| Language | English |
Provides steps to create a new project, select templates, and save project configurations.
Covers initial hardware configuration steps, including setting controller names and IP addresses.
Details the process of setting fixed IP addresses for controller Ethernet ports.
Explains how to add and configure I/O modules for ControlEdge 900 and 2020 controllers.
Introduces general programming concepts and procedures using the IEC 61131-3 standard.
Details how to create and declare local or global variables for system diagnostics and monitoring.
Explains how to create Programs, Function Blocks, and Functions as independent software units.
Describes how to associate programs with tasks to determine their execution scheduling.
Guides on compiling the project, including using Make and Rebuild Project commands.
Provides steps to connect to a physical controller or controller simulator via ControlEdge Builder.
Guides on downloading a compiled project to the controller after successful compilation.
Provides general guidelines and prerequisites for upgrading controller and device firmware.
Step-by-step instructions for upgrading firmware on a non-redundant controller.
Describes on-process and off-process procedures for upgrading firmware on redundant controllers.
Guides on upgrading firmware for Expansion Processor Modules (EPMs).
Details the process for upgrading firmware on ControlEdge 900 I/O modules.
Explains how to upgrade firmware for serial communication modules.
Provides instructions for upgrading firmware on ControlEdge 2020 Expansion I/O modules.
Covers upgrading radio and application firmware for FDAPs and field devices wirelessly.
Details the procedure for upgrading firmware on field devices at the farthest network hop.
Guides on upgrading firmware for Field Device Access Points (FDAPs).
Explains how to upload an archived project from the controller to ControlEdge Builder.
Covers configuring controllers as Modbus TCP Slave or Modbus Serial Slave devices.
Details steps to set up a controller as a Modbus TCP or Serial Slave.
Guides on setting up a controller as a Modbus TCP Master for communication with slave devices.
Explains how to configure a controller as a Modbus Serial Master for serial port communication.
Explains the operating modes for CPMs (Stop Locked, Run Locked, Running, Stopped) and their functionalities.
To Next Page