Need help?Do you have a question about the Honeywell ControlEdge 900R04-0200 and is the answer not in the manual?
General| Brand | Honeywell |
|---|---|
| Model | ControlEdge 900R04-0200 |
| Category | Controller |
| Language | English |
Details the changes made to the document across different revisions.
Identifies the target users and their expected roles for this guide.
Outlines the necessary knowledge and experience required for users.
Provides background information on the ControlEdge technology.
Lists other Honeywell publications relevant to the document's content.
Describes the system architectures for ControlEdge PLC and RTU.
Details the ControlEdge 900 platform and its core components.
Covers assembly, installation, and wiring procedures for the 900 series.
Discusses I/O topologies and power-on steps for the 900 series.
Details the ControlEdge 2020 platform and its core components.
Covers assembly, installation, and wiring procedures for the 2020 series.
Discusses I/O topologies and power-on steps for the 2020 series.
Guide to installing the ControlEdge Builder software on a PC.
Steps to start the ControlEdge Builder application and its start page.
Verifying hardware firmware compatibility before configuration.
Steps for creating a new project in ControlEdge Builder.
Settings for controller name, IP address, and startup behavior.
Procedures for adding and configuring I/O modules.
Guide to adding and configuring serial communication modules.
Instructions for setting up and using a controller simulator.
Introduction to programming using the IEC 61131-3 standard.
Procedures for establishing communication with controllers.
Steps to transfer compiled project files to the controller.
Setting controller time and time zone synchronization.
Guide to updating controller and module firmware versions.
Process for retrieving archived projects from controllers.
Setting up Modbus slave and master configurations.
Setting up EtherNet/IP clients, servers, and devices.
Configuring OPC UA server and client for data access.
Establishing communication with Experion using OPC UA protocol.
Setting up the controller as a DNP3 slave device.
Establishing communication with Experion using DNP3 protocol.
Configuring HART-IP client and HART function blocks.
Setting up Control Data Access communication.
Configuring ISA100 wireless networks and devices.
Custom serial port protocol configuration.
Integrating Field Device Manager for asset management.
Setting up networks within FDM for PLC/RTU devices.
Discovering and adding devices to the FDM network.
Managing user access and privileges with passwords.
Configuring controller operating modes (Stop, Run).
Information on the controller's integrated firewall settings.
Securing network traffic using IPsec policies.
To Next Page