Need help?Do you have a question about the Honeywell ControlEdge 2020 SC-TEPR01 and is the answer not in the manual?
General| Model | SC-TEPR01 |
|---|---|
| Category | Controller |
| Series | ControlEdge 2020 |
| Power Supply | 24V DC |
| Enclosure Rating | IP20 |
| Operating Temperature | -40 to 70 °C |
| Inputs | Digital and Analog Inputs |
| Outputs | Digital and Analog Outputs |
| Communication | Ethernet, Serial |
Provides system and resolution requirements for installing ControlEdge Builder, along with installation steps.
Details the process of creating a new project, selecting templates, and saving project configurations within ControlEdge Builder.
Covers setting controller name, IP addresses for non-redundant and redundant controllers, and their factory default settings.
Explains the procedures for disabling and enabling controller redundancy, including IP address configuration implications.
Guides on configuring onboard and expansion I/O modules for ControlEdge 900 and 2020 controllers, including third-party I/O.
Introduces general programming concepts using IEC 61131-3, including adding libraries, creating data types, variables, and POUs.
Details how to connect to a physical controller or simulator using ControlEdge Builder, including selecting controller type and credentials.
Outlines the steps for downloading a compiled project to the controller, ensuring prerequisites are met and handling different download scenarios.
Provides general information and prerequisites for upgrading firmware on controllers, EPMs, I/O modules, and field devices.
Step-by-step guide for upgrading firmware on non-redundant controllers, including interactive and non-interactive modes.
Details on-process and off-process procedures for upgrading firmware on redundant controllers, with specific steps for ControlEdge 2020 and 900.
Covers setting up controllers as Modbus TCP Slave, Modbus TCP Master, and Modbus Serial Master, including protocol binding and parameters.
Outlines steps for configuring IPsec to support secure communications between Experion and controllers, involving certificate creation and policy setup.
To Next Page