27
For more information about each I/O module wiring, see "Terminal
Block-to-Field (Signal) Wiring" in the ControlEdge 900 Platform
Hardware Planning and Installation Guide.
I/O network Topology
ControlEdge PLC can be configured as a redundant controller system
or non-redundant controller system. It includes provisions for
communication via Ethernet with host systems and the Ethernet ports
provide a layer of protection against cyberattacks. Honeywell
recommends use of Solarwinds and/or Honeywell Risk Manager to
detect unintended and excess network traffic.
ControlEdge PLC supports star and ring I/O topologies for I/O
communication.
Star Topology
The following diagram shows an example of the star topology. A
switch is required for this topology.
Chapter 3 - Hardware
To Next Page
Loading...
Need help?
General
