97
Namespace
Index
Namespace Description
3 http://PLCopen.org/OpcUa/IEC61131-
3/
Namespace for NodeIds and
BrowseNames defined in [PLC].
5 URN: Honeywell:UA:ControlEdgePLC Namespace for NodeIds and
BrowseNames of nodes used to
access the underlying
ControlEdge 900 controller
data.
The exception is when these
nodes provide a standard
Property in which case the
BrowseName shall have the
namespace of the standards
body, even though the NodeId
will use this namespace. For
example, the ParameterSet and
the GlobalVars object
components of eclrRes shown
in section 6.1 - the
BrowseName for ParameterSet
will use [DI] namespace and the
BrowseName for GlobalVars will
use the [PLC] namespace.
Namespace Uri is used for OPC
UA client to get the
NameSpaceIndex.
Configuring an OPC UA Client
This section only introduces simple procedures to configure the OPC
UA Client. For more information, see "OPC UA Client" in the
ControlEgde Builder Protocol Configuration Reference Guide.
Binding protocol to Ethernet ports
You must establish the physical address or endpoint that enables
ControlEdge 900 controller OPC UA client access to the OPC UA
Server.
Chapter 6 - Communication
To Next Page
Loading...
Need help?
General
