69-1642 16
NOTE: Program times are in 15 minute intervals. For example, 8:00, 8:15, 8:30.
❑ Press or until the desired wake temperature displays.
The setpoint temperature range is 40°F to 90°F (4.5°C to 32°C) for heating and 45°F to 99°F (7°C to 37°C) for cooling.
❑ Press to switch between setpoints.
NOTE: Program times are the same for heating and cooling.
❑ Press or until the display shows the desired temperature setpoint.
❑ Press , or and repeat these steps for each program period. The First Day is now
programmed.
❑ Repeat each step in Program the First Day for the rest of the week.
NOTE: After the first day is programmed, you can copy that day to any other day using procedure in Copy a Day.
❑ Press when the entire week is programmed.
Copy a Day
Your thermostat can copy program settings from one day to another.
❑ Press , , or to enter programming mode.
❑ Press until the display shows the day you want to copy.
❑ Press . The display shows.
Heat/Cool
Settings
Leave
Return
Sleep
Run
Program
Wake
Leave
Return
Sleep
Day
To Next Page
Loading...
Need help?
General
