17 69-1642
❑ Press until the display shows the day you want to copy to.
❑ Press to accept the change.
❑ Repeat these steps for each day you want to copy.
NOTE: donE appears for two seconds and then the normal program display appears.
Clear a Program Period
NOTE: Wake cannot be cleared.
❑ Press , , or for the program period you want to clear.
❑ Press until the desired day displays.
❑ Press and hold the , , or for approximately 3 seconds until the time and temperature clear.
❑ Repeat the above steps for each period to be cleared.
❑ Press .
STEP 11. OPERATING YOUR THERMOSTAT
Change Temperature Setting Until the Next Program Period (Temporary Change)
❑ Press or until the screen shows the desired temperature setting.
NOTE: The temporary temperature setting is displayed for about 3 seconds and then the room temperature is dis-
played. Temporary appears in the display. The setting cancels when the next program period starts or when
you press .
To Next Page
Loading...
Need help?
General
