5
Change mode
Idle mode
Change temperature
Warmer Cooler
Symbol Mode
Heat mode - the ductless unit warms the space to the
temperature shown on the controller.
Cool mode - the ductless unit cools the space to the
temperature shown on the controller.
[screen is
blank]
Off mode - the ductless unit is turned off
Room temperature
Any time the controller is not being interacted with, the current room
temperature is displayed on screen.
Viewing set temperature
Be sure the controller is not in Idle mode, then press
+
or
-
once to view
the current set temperature. The set temperature will “pulse” on screen.
After a short period of time the screen will change to display the room
temperature.
Change temperature
1. Be sure the controller is not in Idle mode, then press
+
or
-
more
than once to change the set temperature so it is higher or lower in the
current mode.
2. Stop pressing
+
or
-
when you reach the temperature you want.
3. The screen will pulse and then return to the room temperature
display.
1. Be sure the controller is not in Idle mode, then press
o to change the
system mode.
2. Stop pressing
o when you reach the mode you want.
The ductless unit will beep when it gets a command from the controller.
The controller goes into Idle mode (the screen is dim) after 45 seconds of
inactivity. Press any button to wake up the controller. The wake up button
push does not change temperature or settings.
To Next Page
Loading...
Need help?
General
