Honeywell DBC1500 Series - User Manual

HWLKS-E-M-2106-R1
1
DIGITAL BURNER CONTROLLER
DBC1500 SERIES
1. APPLICATION
The Honeywell DBC1500 is a microprocessor-based
integrated burner controller for automatically fired
gas, oil or combination fuel industrial single burner
applications. The DBC1500 system consists of the
relay module and wiring sub base. The DBC1500
Standard Model provides the minimum
requirements to control an industrial burner system,
such as automatic burner sequencing, flame
supervision, system status indication, system or
self-diagnostics and troubleshooting.
The DBC1500 is programmed to provide a level of
safety, functional capability and features beyond
the capacity of conventional controls.
2. FEATURES
 Employs a plug-in mounting method
 Uses a microprocessor to improve performance
 Status and fault indication by indicator LEDs
 Safe start check before and during pre-purge
 Dual flame amplifier for UV, IR or flame rod sensor
 Automatic one time re-try function
 Frontal jack plug (Ø 3.5mm) to read the flame
signal with a microampere meter.
 Safety shutdown occurs on
- malfunction of the burner controller
- failure to ignite the pilot burner or main burner
- loss of flame during run period
- opening of air flow switch during pre-purge, start-
up and run period
- flame signal detection during standby or pre-
purge period
Contents
1. Application 1
2. Features 1
3. Specifications 2
4. Dimensions 5
5. Installation and wiring 6
6. Operation 11
7. Trouble shooting 13
INSTALLATION INSTRUCTIONS
Important note:
Subject to changes without notice.
All rights reserved.

Honeywell DBC1500 Series Specifications