9
6. Connect the terminal to one of the 99EX series
charging peripherals to charge the main battery pack.
We recommend use of Honeywell Li-poly or Li-ion battery
packs. Use of any non-Honeywell battery may result in
damage not covered by the warranty.
Battery Error Notification
If your terminal displays the following indicators, replace
the battery with a new Honeywell battery pack.
Note: Replace only with battery pack model 99EX-BTSC (PN 99EX-
BTSC-2) or 99EX-BTEC (PN 99EX-BTEC-2), manufactured for
Honeywell International Inc.
• appears in the Title bar at the top of the touch panel
display.
• The General Notification LED flashes red.
• A notification appears on the Tile bar at the bottom of
the touch panel display.
Removing the Main Battery Pack
Before you attempt to use, charge, or replace the battery in
the terminal, carefully read all the information under
Equipment for Use in Hazardous Locations (see page 1).
When removing a battery from the terminal, put the device
in Suspend Mode (see page 12) before removing the
battery door. Once the battery door is removed, wait at
least 3 seconds before removing the main battery. This
process allows the device to shut down properly and to
maintain memory during the battery swap.
To Next Page
Loading...
