20
Installing a Memory Card
Carefully read all the information under “Equipment for Use in
Hazardous Locations” on page 1 before you attempt to install a
card.
Honeywell recommends the use of Single Level Cell
(SLC) industrial grade microSD™ or microSDHC™
memory cards with Dolphin terminals for maximum
performance and durability. Contact a Honeywell sales
representative for additional information on qualified
memory card options.
Note: Format all microSD/SDHC cards before initial use.
1. Press the Power key to put
the terminal in Suspend Mode.
2. Release the hand strap hook
near the speaker on the back
panel of the terminal.
3. Remove the battery door.
4. Wait at least 3 seconds, then
remove the battery.
5. Remove the T6 TORX screw
securing the protective door
closed.
6. Lift up the lower left corner of
the door to access the memory
socket.
7. Unlock the access door to the
socket by sliding the door
toward the IrDA port side of the
terminal.
To Next Page
Loading...
