5
Install a microSD Card (SD)
Note: Format the microSD card before initial use.
1. Remove the two screws holding the card access door
closed.
2. Pull gently on the tab to open the door.
3. Press down gently on the center card holder.
4. Slide the holder toward the bottom of the unit, and then lift
up the edge.
5. Insert the microSD card into the card holder with the
contacts facing out.
6. Close the holder with the card inserted.
7. Press down gently on the holder and slide it into the locked
position.
8. Close the card access door.
9. Install the two screws to secure the door closed.
Always power off the computer before attempting to
install or remove a card.
Draft, Not for Release, 2/7/18
To Next Page
Loading...
