6
Install a microSIM Card (SIM 1 or SIM 2)
Note: Model CT60L0N only supports UICC SE NFC technology through
the SIM 1 card socket. On CT60L1N models, the SIM 1 socket
supports both cellular and NFC UICC SE functionality.
1. Remove the two screws holding the card access door
closed.
2. Pull gently on the tab to open the door.
3. Press down gently on one of the following:
• the far left card holder for SIM 1 installation, or
• the far right card holder for SIM 2 installation.
4. Slide the holder toward the bottom of the unit, and then lift
up the edge.
5. Insert the SIM card into the card holder with the contacts
facing out.
6. Close the holder with the card inserted.
7. Press down gently on the holder and slide it into the locked
position.
8. Close the card access door.
9. Install the two screws to secure the door closed.
Always power off the computer before attempting to
install or remove a card.
Draft, Not for Release, 2/7/18
To Next Page
Loading...
