E528 Product Guide
Rev 8.0 12/16/2016 5
Mounting
The e528 is usually mounted on a standard double-gang (4 x 4) junction box. If
mounted on a single-gang box, the left side (display side) of the e528 overlaps
the wall area to the left of the junction box. A low-voltage mounting plate, mud
ring, or low-voltage caddy may be used for mounting 24 volt applications.
To mount the e528:
1. Remove the two small screws at the base of the e528.
2. Pull the bottom of the back-mounting plate slightly away from the front
housing and then pull the back-mounting plate down.
3. Position the back plate insulator within the mounting plate as shown i
n
F
igure 4.
4. Attach the mounting plate to the junction box, using the mounting screws
provided with the e528. Ensure that the plate is mounted with the rais
ed
arrow pointing UP.
To simplify installing and removing the e528, the headers and sockets
described below and shown in Figure 5 are located on the back of the
e528. These accept pre-made wiring harnesses provided by INNCOM.
(Note: Take care to note which e528 model is being used. Each model
has slightly changed headers and connectors as identified in the
drawings on the next page.)
Figure 4 Mounting Assembly
Mounting Box Back Mounting Plate Back Plate Insulator
To Next Page
Loading...
Need help?
General
