Need help?Do you have a question about the Honeywell INNCOM e7 and is the answer not in the manual?
General| Connectivity | Wired |
|---|---|
| Power Supply | 24V AC |
| Compatibility | HVAC systems |
| Mounting | Wall-mounted |
| Model | INNCOM e7 |
| Type | Smart Thermostat |
| Display | LCD Touchscreen |
Follow all instructions carefully before installing equipment.
Install equipment in accordance with National Electric Code and local authority.
Handle product using appropriate ESD grounding techniques to prevent damage.
Always assume hazardous voltages exist and perform safety checks before work.
Avoid electrical work during storms; protect wiring from lightning surges.
Minimize contact with hazardous wiring; provide adequate separation for communications wiring.
Equipment complies with FCC limits for commercial environments; may cause interference.
Details on compatibility, energy management, sensors, and user interface features.
Contact information for technical support and parts orders.
Explanation of display elements and button functions for user control.
List of available part numbers for the e7 thermostat and related kits.
Diagrams and pinouts for connecting power and HVAC signals.
Mapping of thermostat relays to HVAC functions for different system types.
Electrical specifications for relays and power inputs.
Default configuration parameters for HVAC unit control functions.
Example of thermostat operation for a specific FCU configuration.
Procedure to assign a unique network address or Room ID to the thermostat.
Procedure to configure the thermostat for the specific HVAC system type.
Setting the fan speed options for the thermostat.
Steps to exit the initialization process after configuration.
Procedure to reset the thermostat to initialization mode.
Procedure to disable contractor mode and return to normal operation.
Overview of advanced configurations using INNtool and engINN software.
Steps to enter the service mode for testing and configuration.
Test to verify the functionality of the on-board PIR motion sensor.
Test to verify the functionality of the door sensor.
Test to verify the functionality of the window sensor.
Test to verify network connectivity with the INNControl 3 server.
Test to display the measured relative humidity percentage.
Test to verify HVAC system response to temperature changes.
How to change the desired room temperature using the thermostat interface.
How to toggle temperature display between Fahrenheit and Celsius.
How to manually select fan speeds or use auto mode.
How to choose between Off, Auto, Heat Only, and Cool Only modes.
Configuration for VIP mode with expanded temperature control and energy saving features.
Procedure to segregate RF gateways into sub-networks.
Procedure to set the RF channel for optimal communication.
Process to bind a device to the e7 by setting its address.
Process to bind a device and activate its I/O map.
How to bind remote devices like RF locks to the thermostat.
Test to verify communication with an in-room device.
Procedure to reset the e7 thermostat or a remote device.
Procedure to set a specific address for the e7 thermostat.
How to view the firmware versions of the thermostat.
To Next Page
