INNCOM E7 THERMOSTAT USER GUIDE
36-00013—02 20
Normal Operation Mode
During normal operation, guests or other end-users can make the following settings for a room from the e7 thermostat
interface.
ADJUSTING THE TEMPERATURE SET POINT
Enter a room temperature set point using the thermostat UP/DOWN keys. The
set point low limit is 65
o
F, the high limit is 80
o
F (adjustable).
• The e7 room temperature set point defaults to 72
o
F (adjustable) when the
guest enters their room for the first time.
• The e7 thermostat displays the temperature set point as a default. If an
alternative parameter is displayed (such as measured room temperature), the
display reverts to the set point after 10 seconds.
CHANGING TO FAHRENHEIT OR CELSIUS
Using the
o
F|
o
C button, select whether the temperature set point and room
measured temperature are displayed in
o
C or
o
F. Each press of the button
toggles the display between Centigrade and Fahrenheit.
Fahrenheit - °F is displayed next to the temperature which is shown in 1 degree
increments.
Centigrade - °C is displayed next to the temperature which is shown in 0.5
degree increments.
SETTING THE FAN SPEEDS
Pressing the fan button forces the e7 thermostat to exit the default auto mode
and employ a pre-determined a fan speed.
Auto Mode - Fan speed and heating or cooling are automatically selected to
raise or lower room temperature based on the difference between the set point
temperature shown on the display and the measured room temperature.
Low, Medium, and High Fan Speed - Pre-determined fan speeds are selected by
pressing the fan button; successive presses increment the fan speed low to
medium to high (indicated by 1 to 3 vertical dots next to the fan). After the
highest fan speed is reached, if the button is pressed again it initiates another
cycle through the available fan speeds.
Measured Temperature - The measured temperature icon is
displayed above the set temperature on the right when someone
interacts with the thermostat.
Outside Temperature - The measured outside temperature icon
is displayed above the set temperature on the left when the
thermostat is in dormant mode.
To Next Page
Loading...
Need help?
General
