Need help?Do you have a question about the Honeywell equIP H2W2GR1 and is the answer not in the manual?
General| Brand | Honeywell |
|---|---|
| Model | equIP H2W2GR1 |
| Category | Security Camera |
| Language | English |
Provides essential safety guidelines for installation and operation.
Instructions for updating the camera's firmware.
Steps to access the camera's web interface for configuration.
Procedure for initial login and password change.
Step-by-step guide to playing recorded video files.
Adjusting camera properties and video streams.
Adjusting image properties like brightness, contrast, and exposure.
Configuring video stream format, resolution, and frame rate.
Settings for audio input, output, and volume.
Setting up IP addressing, subnet, and gateway.
Configuring IPv4 settings via DHCP or static assignment.
Restricting access based on IP or MAC addresses.
Setting up email notifications for events.
Configuring alarm inputs, outputs, and recording triggers.
Configuring motion detection zones and sensitivity.
Setting up alerts for camera tampering or defocus.
Configuring Intelligent Video System analysis events.
Setting up and configuring face detection parameters.
Configuring people counting analytics and reports.
Setting up daily, weekly, and holiday recording schedules.
Specifying storage locations for recorded data.
Adjusting record length, pre-event recording, and disk full behavior.
Managing user accounts, groups, and permissions.
Restoring the camera to factory default settings.
Procedures for installing new firmware.
To Next Page