Need help?Do you have a question about the Honeywell equIP H3W2GR1V and is the answer not in the manual?
General| Series | equIP |
|---|---|
| Image Sensor | 1/2.8" Progressive Scan CMOS |
| Max. Resolution | 1920 x 1080 |
| Resolution | 1080p |
| Focal Length | 2.8mm |
| Night Vision | Yes |
| IR Distance | 30m |
| Weather Resistance | Yes |
| Ingress Protection | IP66 |
| Impact Protection | IK10 |
| Wide Dynamic Range (WDR) | Yes |
| Power Supply | PoE (802.3af) |
| Operating Temperature | -30°C to 60°C |
| Video Compression | H.265, H.264 |
| Network Interface | Ethernet |
Procedure for updating camera firmware for single or multiple cameras.
Initial login process and password change for the web client.
Adjusting image quality, exposure, WDR, white balance, and day/night settings.
Setting up IPv4, IPv6, and ARP/Ping configurations for network connectivity.
Setting up email notifications for events like alarms or health messages.
Setting up alarm inputs, outputs, delays, and associated actions.
Setting up motion detection areas, sensitivity, and recording triggers.
Detecting and responding to camera tampering or defocus events.
Configuring detection and response to changes in the camera's view.
Setting up detection for audio input abnormalities or intensity changes.
Configuring Intrusion Detection Systems (IVS) rules and parameters.
Setting up face detection parameters and enhancement options.
Configuring people counting analytics, including rule setup and alarms.
Setting up daily, weekly, and holiday schedules for video recording.
Specifying storage paths for recorded video and snapshots (SD card, FTP, NAS).
Adjusting record length, pre-event recording, auto-delete, and disk full behavior.
Managing user accounts, groups, and permissions.
Procedures for resetting the camera to default or factory default settings.
Process for installing new firmware onto the camera.
To Next Page