Honeywell ERM5220R1018 - Mounting ERM

33-00135EFS—05 10
When the ERM is connected to the system, the ERM’s “Connected” LED
will be solid green and the thermostat will show “ERM” in its Wireless
Manager. (Fig. 10)
Fig. 10.
Mounting ERM
9. Use two screws and wall anchors to attach the ERM to the exterior
wall near the compressor. The location should be at least 3 feet
above ground and oriented with the two wire exits facing
downward. See Figs. 11 and 12.
10. Attach cover and secure with bottom screw (Fig. 13).
Fig. 11. Mounting orientation.
OR
MCR35661
CONNECTED LED STATUS
Connect
Flashing: Devic
e Connecting
Gree
n: Device Connected
Red:
Not Communicating
Compressor
Boiler
Connected
MCR35662
CONNECTED LED STATUS
Connect
Flashing: Devic
e Connecting
Gree
n: Device Connected
Red:
Not Communicating
Compressor
Boiler
Connected
MCR35665
MOUNTING
SCREWS
CORRECT
Equipment Remote Module I ERM5000R
Compressor
Boiler
Connected
Connect
CONNECTED LED STATUS
Flashing: Device Connecting
Green: Device Connected
Red: Not Communicating
Compressor:
Jump J and R
Boiler:
Remove Jumper
J
R
C
Y1
Y2
T
O/B
T
D
L
S1
S1
INCORRECTINCORRECT
Equipment Remote Module I ERM5000R
Compressor
Boiler
Connected
Connect
CONNECTED LED STATUS Flashing: Device Connecting Green: Device Connected Red: Not Communicating
Compressor:
Jump J and R
Boiler:
Remove Jumper
J
R
C
Y1
Y2
T
O
/B
T
D
L
S1
S1
Equipment Remote Module I ERM5000R
Compressor
Boiler
Connected
Connect
CONNECTED LED STATUS
Flashing: Device Connecting
Green: Device Connected
Red: Not Communicating
Compressor:
Jump J and R
Boiler:
Remove Jumper
J
R
C
Y1
Y
2
T
O/
B
T
D
L
S1
S1
33-00135EFS_C.book Page 10 Monday, May 2, 2016 1:52 PM