P/N 151443 Rev C
ECN 16-0218
RA-2000 Remote Annunciator
Installation Instruction
The RA-2000, an optional 4x40 Remote Annunciator,
is shown in Figure 1. The RA-2000 can be surface or
flush-mounted and is available in gray color as RA-
2000GRAY.
Figure 1: Model RA-2000GRAY Remote Annunciator
Compatibility
The RA-2000 is compatible with Honeywell’s
Farenhyt Series FACP's.
Note: For more information, see the FACP Installation manual.
Specifications
Mounting
Flush Mounting
Follow these steps to flush mount the RA-2000
1. The backbox measures 9-1/4” W x 8-3/8” H. The
backbox can be mounted prior to the complete
installation of the RA-2000 using any of the
mounting holes shown in Figure 2.
Figure 2: Backbox Mounting Holes
2. Remove knockout holes as needed for wires.
See Figure 3 for backbox knockout locations
Figure 3: Backbox Knockout Locations
3. Wire the annunciator board to the main control
panel. See Figure 7.
4. Attach the annunciator/door assembly to
backbox as shown in Figure 4 using the supplied
Parameter Value
Operating Voltage: 24VDC
Current
Standby: 25mA
Alarm: 50mA
Operating
Temperature:
0° to 49° C (32° to 120° F)
Dimensions:
Flush
Mount:
Overall: 12¼” W x 11½” H x 7/8” D
(31.1 cm W x 29.2 cm H x 2.2 cm
D) See “Flush Mounting” for back-
box dimensions.
Surface
Mount:
Including trim ring:
12¼” W x 11½” H x 3” D
31.1 cm W x 29.2 cm H x 7.6 cm D
mounting holes
mounting holes
wire knockouts
wire knockouts
wire knockouts
To Next Page
Need help?
General
