Honeywell FocusPRO - Install batteries; Link thermostat(s) to wireless network

Install batteries
1
Press
CONNECT
button at EIM or wireless adapter and wait for green flashing
light, then follow steps below.
Install quick reference card
Install 2 fresh AA batteries
2
FocusPRO
®
Thermostat Installation Guide
Programmable models only
Link thermostat(s) to wireless network
2
Wireless Setup
0
1
NextBack
Wireless Setup
36
52
Back Next
Wireless SetupWireless Setup
Back
Installation with EIM: Press
NEXT
(leave
zone number set to zero).
Installation with TrueZONE panel:
Press
▲ or ▼ to set a zone number for this
thermostat (1 to 4), then press
NEXT
.
Installation with EIM:
Press
NEXT
.
Installation with TrueZONE panel:
Press
▲ or ▼ to select a name for this zone, then
press
NEXT
(see list of names on page 6).
Press CONNECT
to establish a link to the
wireless network.
After a brief pause, the confirmation
screen at left should be displayed, to
verify that the wireless connection has
been established.
Press
DONE
to display the home screen.
Wireless SetupWireless Setup
Connected
Done
Zone nameZone number
Connect
If E1 appears, see error codes on page 3.