Honeywell FocusPRO - Customize thermostat (installer setup); Thermostat error codes

3
Español: vea la página 9 • Français : voir la page 17
Customize thermostat (installer setup)
3
Function Setting
Press ▲ or ▼ to change setting
(see tables on pages 4-6)
Press
NEXT
to display next
function screen
Press DONE to save & exit.
Follow the steps below to begin installer setup. At each function screen,
press
▲ or ▼ to change the setting as desired, then press
NEXT
to advance to
the next function screen.
See tables on pages 4-6 for a description of options for each function.
1
0
Back NextDone
0
1
BackDone Next
To begin, press and hold the
FAN
and ▲ buttons
until the display changes (about 3 seconds).
Thermostat error codes
If E1 appears during setup, check error code number (right side of screen):
29 You are attempting to connect a thermostat to an incompatible device.
30 Zone number must match zone panel number (must be zero for EIM systems).
31 Verify that this zone number is configured at the zone panel as an RF thermostat.
33 Faulty return air sensor. Check wiring or replace sensor as needed.
34 Low signal strength. Move wireless device to a different location and try again.
38 Make sure Connected light is flashing and you are 2+ feet away from EIM or
wireless adapter.
FAN