Honeywell Granit 1280i - Insert a Delay; Discard Data; Data Formatter

5 - 11
Syntax = B8.
Note: The B8 command must be entered after all other commands.
The Data Format must be (see page 5-11) in order for the B8 command to work.
If Data Format is (page 5-12), bar code data that meets the B8 format is scanned and output
as usual.
Because the data format needs to be and (page 5-12) for the B8 command, you must input data formats
for all bar codes you wish to discard as well as all bar codes you wish to output.
Other data format settings impact the B8 command. If Data Format Non-Match Error Tone is (page 5-12), the
scanner emits an error tone. If Data format Non-Match Error Tone is , the code is disabled for reading and no
tone is sounded.
not are