Honeywell GSMX - Using the 7720 P Programming Tool

GSMX Installation and Setup Guide
– 9 –
TEST MESSAGE/REGISTRATION
Switch
GSMX-007-V0
Using the 7720P Programming Tool
Ensure the GSMX is powered, and connect
the 7720P Programming Tool.
Each key has two possible functions; a Normal function and a Shift function.
• To perform a Normal key function, simply press the desired key.
• To perform a Shift function, press the [shift] key, then press the
appropriate key.
The following table lists each normal and shift key function.
7720P Normal and Shift Key (shift LED lit) Functions
KEY NORMAL KEY FUNCTION SHIFT + KEY FUNCTION
BS/ESC [BS]: Press to delete entry [ESC]: Press to quit program mode;
also can reset programming
defaults.*
↓/↑ [↓]: Scroll down programming [↑]: Scroll up programming
N/Y [N]: Press for "NO" answer [Y]: Press for "YES" answer
SHIFT Press before pressing a SHIFT key function. Will light SHIFT LED. LED
goes out once a key is pressed. Press again for each SHIFT function
desired.
1/A [1]: For entering the number 1 [A]: For entering letter A
2/B [2]: For entering the number 2 [B]: For entering letter B
3/C [3]: For entering the number 3 [C]: For entering letter C
4/D [4]: For entering the number 4 [D]: For entering letter D
5/E [5]: For entering the number 5 [E]: For entering letter E
6/F [6]: For entering the number 6 [F]: For entering letter F
7/S [7]: For entering the number 7 [S]: For entering letter S
8/T [8]: For entering the number 8 [T]: For entering letter T
9/X [9]: For entering the number 9 [X]: For entering letter X