GSMX Installation and Setup Guide
– 18 –
PROMPTS ENTRY OPTIONS DESCRIPTION
21
Review?
Y/N
[Y] =
review
[N] = exit
Reviewing Programming
Mode Entries
To review the programming
options (to ensure that the correct
entries have been made), press
[Y]. The programming prompts
are displayed again. Use the
up/down arrow keys to scroll
through the program fields
without changing any of the
values. If a value requires
change, simply type in the correct
value. When the last field is
displayed, the “REVIEW?”
prompt again appears.
To exit the programming
mode, press [N] in response to
the "REVIEW?" prompt, and refer
to Exiting Programming Mode
topic.
ECP Status Codes
The GSMX sends status messages to the control panel to report various
failures. Some control panels, (e.g., VISTA-10P, VISTA-15P and VISTA-20P
Series) display these status codes on the keypad as “LngRng Radio” followed
by a 4-digit code. Commercial panels can supervise the communicator
module by way of its ECP address, ex: 03. For example, if the module is
disconnected, if it's not registered, or the SIM is deactivated, a "Check 803"
will be displayed.
The control panel will display a fault message if any of the events listed
below occur.
• Module lost communications with the control panel.
• Module lost contact with AlarmNet.
• Module is not registered; account not activated.
• Module shutdown.
In addition, the Contact ID codes for some of these conditions are reported by
the control panel and sent by AlarmNet to the central station.
To Next Page
Loading...
