GSMX Installation and Setup Guide
– 14 –
PROMPTS ENTRY OPTIONS DESCRIPTION
5
Change
Password?
(Y/N)_
[Y], [N] If a password has already been
assigned, this prompt appears
after pressing [N] at the
"Program Device?" prompt.
Press [Y] if you want to change
the password.
NOTE: To clear an existing
password, without entering a new
one, answer [Y] to the "Change
Password?" prompt, then press
the [Enter] key when prompted
for the new password and its
confirmation.
6
Enter
Password
[0-9, A-F,
N, S, T, X,
Y]
This prompt is displayed if [Y]
was pressed in Prompt 4 or 5.
Enter a 4-digit password
(0-9, A-F, N, S, T, X, Y).
7
Verify
Password
[0-9, A-F,
N, S, T, X,
Y]
Re-enter the password as
confirmation.
If the password doesn't match the
first entry, the following is
displayed followed by the "Exit
Prog. Mode?" prompt:
Verify Not OK
PSWD not created
Otherwise, the "Exit Prog. Mode?"
prompt is displayed directly.
8
Exit Prog.
Mode?
(Y/N)_
[Y], [N]
[ESC]
Exits program mode.
Press [N] to go back to Prompt 3.
Press [ESC] to load factory
defaults.
Refer to the Exiting the
Programming Mode topic.
9
Device
Mode
(ECP)_
• ECP
• 4204
Emu
• Two
4204s
Press the [space] key to scroll
through the modes of operation.
Press [ENTER] to select the
desired mode.
To Next Page
Loading...
