Honeywell GSMX - Primary Account Information; Remote Access Setup

GSMX Installation and Setup Guide
– 16 –
PROMPTS ENTRY OPTIONS DESCRIPTION
NOTE: Account information is provided by the central station administrator.
12
Primary City
ID
(??)_
[01-99]
Enter the 2-digit primary city ID,
01-99 (decimal).
13
Primary CS
ID
(??)
[01-FE] Enter the 2-digit primary central
station ID number, 01-FE (HEX).
14
Primary Sub
ID
(????)
[0001-
9999]
Enter the 4-digit subscriber
account number, 0001-9999
(decimal).
15
Device
Address
(03)_
[01-30] The module communicates with
the panel as a Long Range Radio
(LRR) device. Enter ECP device
address.
NOTE: When programming the
control, enable the LRR output.
Setting up the Remote Access Feature
Remote Access enables the user to control the security system using a web browser.
This feature must be configured at the AlarmNet Direct website
as follows:
• Remote Access must be enabled by selecting "Enabled" at the Remote Access
prompt.
• A keypad address must be enabled in the GSMX in order for the module to
communicate with the control panel.
• At the “Keypad Type” prompt, select the appropriate Keypad.
16
Remote
Access
Y/N
(N)_
[Y], [N] Press [Y] to allow the end user to
access their system via a website.
Availability of this service is
controlled by the dealer via the
web-based programming tool on
the AlarmNet Direct website.
17
Keypad
Address
(28)_
[01-30] NOTE: This prompt will only
appear if the Remote Access
feature has been enabled.
Must be programmed if using the
Remote Access feature. Enter the
appropriate device address.