Honeywell H2W2PER3 - Configuring Storage Settings; Configuring Schedule Settings; Configuring Record Schedule

Performance Series IP Camera Software Configuration Guide
60
8 Configuring Storage Settings
This chapter contains the following sections:
• Configuring Schedule Settings, page 60
• Configuring Destination Settings, page 61
• Configuring Recording Control, page 64
Configuring Schedule Settings
Configuring Record Schedule
Go to Setup Storage Setup Schedule  Record Schedule.
You can add or remove schedules for recording. There are three recording modes: General
(auto), Motion, and Alarm. You can configure up to nine recording periods per day.
Figure 8-1 Record Schedule
Record Schedule Color Codes:
• Green: General recording
• Yellow: Motion detection recording
• Red: Alarm recording
Configuring Snapshot Schedule
Follow the same procedure to configure the settings on the Record Schedule tab.