Operation SDC / DHC
54 EN2H-0220GE51 R1111
4.2.3.3.3 Individualised operating mode for each heating circuit
Each heating circuit can be assigned an individualised operating
mode.
► Press button.
► Select desired heating circuit (HC, MC-1 or MC-2) by turning
the input button
î.
► Confirm selected circuit by pressing the input button
î.
► Select flashing operating mode by turning the input button
î.
► Confirm set operating mode by pressing the
button or the
input button
î.
► With short-term operating modes (ABSENT, PARTY), set
desired target value by turning the input button
î and confirm
set value by pressing the input button
î.
Alternative: Automatic acceptance of the value after the set
information time (see 4.1.2.7 "System information" button, pg. 26).
Pos: 50 /156-Hon eywell/ Bedienung /Somm er_Heizgre nze @ 1\m od_120 76470582 44_6.do c @ 9900
4.2.3.4 Summer / Heating limit
This parameter specifies the end of heating operation depending
on the outside temperature based on the following criteria:
Quick increase in outside temperature
If the averaged outside temperature is below the set value and
the current outside temperature is 2 K above the set value,
heating operation is interrupted.
Slow increase in outside temperature
Deactivation is also initiated when the averaged and current
outside temperature exceeds the set value.
Setting
C
To Next Page
Loading...
