Performance Series Network Video Recorder User Guide
216
Figure 12-90 Date & Time Configuration Interface
Table 12-28 Date & Time Configurations
Configuration Description
Date Format Select the date format from the drop-down list.
Time Format Select from either 24 hour or 12 hour.
Date Separator Select from a period (.), a hyphen (-), or a slash (/).
System Time Set the NVR’s time. You have to Save to activate this setting.
Sync PC Click to synchronize your NVR’s time with your PC’s time.
Time Zone Select a Time Zone for the NVR.
DST
Click to enable Daylight Saving Time (DST). Click to select a type, either
Date or Week. Then configure a date and time when DST begins and
ends.
NTP Click to enable the NTP server.
NTP Server Enter the NTP time server address.
Port Enter the NTP time server port.
Upgrade Interval
Configure the synchronization period between the NVR and the NTP
time server.
Holiday Settings
1. Click the Holiday tab in the GENERAL settings configuration interface to open the
Holiday Setup configuration interface.
To Next Page
Loading...