Honeywell HEN081 4 Series - Adding a Camera Manually

Performance Series Network Video Recorder User Guide
54
a. Click to select the found camera.
b. Click Add to add the found device to the Added Device list.
Note
If the NVR fails to display the model name of a found device,
click Device Search to rediscover the online devices. The model
name should appear in the Found Devices list.
Adding a Camera Manually
Click Manual Add and manually configure the following settings:
Table 6-1 Manual Add
Parameter Function
Manufacturer
Select the manufacturer that applies to your camera from
the list.
IP Address Enter the IP address for the camera.
TCP Port Enter the TCP port for the camera. (Optional)
Username Enter a username.
Password Enter a password
Channel No.
Enter a channel amount or click the Connect button to get
the channel amount of the remote device.
Note: We recommend click the Connect button to get
remote device channel amount, the manual add operation
may result in failure if the input channel amount is not
right.
Remote
Channel No.
After getting the remote device channel amount, click
Setup to select a channel.
Note: Click to select one or more remote channel numbers
here.
Channel
The local channel number you want to add. One channel
name has corresponding one channel number.
Decode buffer Select from the drop-down menu of options.
Click OK. The newly added camera appears in the Added Device list.