www.honeywell.com/security
66 | Performance Series IP Camera User Guide
To enable scene change detection:
1. Select the Enable check box.
2. Next to Working Period, click Setup. The Working Period window opens.
3. Set the days and times when you want the alarm function to be active, then click Save.
4. To start recording video when a scene change event is detected, select the Record
check box.
5. In the Record Delay field, enter the number of seconds that the system will continue to
record video after a scene change event has ended. Enter a value between 10 and 300.
6. To send an email notification when an alarm event is detected, select the Send Email
check box. Email settings must be configured in Setup > Network > SMTP (Email). See
Configuring Email Settings on page 49.
7. To take a snapshot when an alarm event is detected, ensure that the Snapshot check
box is selected.
Note For the snapshot to be attached to the email notification, the Attachment
check box must be selected in Setup > Network > SMTP (Email).
See Configuring Email Settings on page 49.
8. Click Save to apply the settings.
To Next Page
Loading...
Need help?
General
