Honeywell HW2000i - Portable Inverter Generator

Questions and Answers

D
deborahgrayJul 26, 2025
What to do if my Honeywell HW2000i - Portable Inverter Generator has no power at the receptacle?
- K
  kevin79Jul 26, 2025
  If your Honeywell Portable Generator has no power at the receptacle, there may be an electrical overload. Check the circuit breaker for a tripped position or if the overload DC indicator light is on. Reduce the electrical load on the circuit, wait several minutes, and then push to reset the circuit breaker. Also, a circuit breaker might be defective and need replacement. Check the cord connection, and replace any defective cord sets. Finally, the connected electrical appliance/equipment could be defective; in this case, disconnect the defective appliance/equipment from the generator and have it serviced by a qualified repair facility.
D
Debra DominguezAug 2, 2025
How to fix Honeywell HW2000i - Portable Inverter Generator Portable Generator engine that will not start?
- L
  Lisa RobertsAug 3, 2025
  If your Honeywell Portable Generator engine will not start or starts and runs roughly, make sure the engine switch or fuel valve is turned on. Add fuel if the tank is empty, or drain the tank and fill it with fresh fuel if the fuel is stale. Check and add engine oil if the level is low. Ensure the spark plug wire (cap) is connected and that the spark plug is not faulty; replace if necessary. For the HW2000i model, pump fuel into the carburetor. Additionally, check if the air filter or spark arrestor screen are dirty; clean or replace them as needed.
D
Dana GonzalesAug 9, 2025
Why does my Honeywell HW2000i - Portable Inverter Generator Portable Generator engine suddenly stop?
- J
  jimmybradyAug 10, 2025
  If your Honeywell Portable Generator engine suddenly stops, it could be due to lack of fuel. Add fuel to the generator. Also, check the engine oil level and add oil if it's low.
D
Donna WongAug 16, 2025
How to troubleshoot low power at receptacles on Honeywell Portable Generator?
- A
  Amy NelsonAug 16, 2025
  If your Honeywell Portable Generator has low power at the receptacles, it might be because of a dirty air filter or a dirty spark arrestor screen; clean or replace them. Also, stale fuel can cause this issue; drain the fuel tank and fill it with fresh fuel.

Honeywell HW2000i - Portable Inverter Generator Specifications

General

Fuel Type	Gasoline
Start Type	Recoil
AC Voltage	120 V
Engine Displacement	79 cc
Parallel Capable	Yes
Inverter Technology	Yes
THD	<3%
Engine Type	4-Stroke OHV
Outlets	2
Type	Inverter
Running Watts	1600 watts
Dimensions	17.9 in