9
USE & OPERATION (CONTINUED)
EN
FUNCTION BUTTONS (CONTINUED)
While the unit is turned on, press the timer button and then press the + or - to select the number of
hours you would like the unit to continue to run. The unit will turn off automatically.
AUTO TURN OFF:
While unit is running, press the button and the display will flash. While the display is flashing,
press the + or - button to select the number of hours after which you want the unit to turn OFF
automatically.
AUTO TURN ON:
When the unit is in a standby mode, press the button first and then press the + or - button to
select the number of hours until you want the unit to automatically start running.
Note: The time is adjustable between 1 - 24 hours.
TIMER CONTROL
Condensate may accumulate in the unit.
If the internal tank becomes full, the warning light will flash and beep 10 times. The unit will not
operate until the unit has been drained (refer to Water Condensate Drainage).
After switching the air conditioner off, you must wait 3 minutes before switching it back on again.
WARNING LIGHT
WATER FULL LIGHT
Condensate may accumulate in the unit.
If the internal tank becomes full, the Water Full Light will illuminate. The unit will not operate until
the tank has been drained (refer to the "Water Condensate Drainage" section).
To Next Page
Loading...
Need help?
General
