11. SLEEP
• Press this button to enter SLEEP mode, which the unit will exit after 10 hours of
continuous operation and restore to the previous status.
NOTE: The SLEEP function cannot be activated in FAN mode.
12. SWING (Vertically)
• Press this button to activate up/down swing and press it again to reset the swing
position.
13. SWING (Horizontally)
• Press this button to activate left/right swing and press it again to reset the swing
position.
14. ANTI-M
• The Anti-M functions when the unit is turned off with the remote controller in
COOL, DRY or AUTO mode. It will operate in HEAT mode (FAN mode for cool only
units), with the internal fan running with weak flow for 3 minutes before stop, to
remove the moisture within the evaporator so as to prevent it from giving off any
bad smells from mold.
• This function is not set in the factory. It may be set or cancelled any time as
follows: With the unit ON, press “Anti-M” button once, the buzzer will sound 5
times, indicating this function is set. Once set, this function will remain active
except when the unit is powered off or until it is cancelled.
• To cancel Anti-M:
1. Power off the unit.
2. With both the unit and the remote controller OFF, point the remote
controller at the unit and press this button once, the buzzer will sound 3
times, indicating this function is canceled.
NOTE:
• With Anti-M activated, do not turn the unit ON again before it is fully OFF.
• Anti-M function will not function when the OFF timer is set.
15. ECO
• If this button is pressed in COOL mode, the unit will enter ECO mode which has the
lowest electricity consumption and exit it automatically 8 hours after.
• Changing modes or turning off the remote controller will automatically cancel the
ECO function.
• Press ECO button in ECO mode to exit this mode.
23
REMOTE CONTROL FUNCTIONS
To Next Page
Loading...
Need help?
General
