IHR810 User Manual
www.impactbyhoneywell.com
47.
9. DHCP Set:
The "DHCP set" function is used to automatically turn on and off IP addresses.
1. Enable DHCP
select “ON” option and click on “DHCP Set.”
2. Disable DHCP
select “OFF” option and click on “DHCP Set.”
10. Network Settings:
It includes "Network Settings" and "Bluetooth Settings"
IHR810
（Network Settings）.
（Bluetooth Settings）.
1. Set up the Printer’s IP address.
2. Set up the Subnet Mask.
3. Set up the Gateway.
4. WIFI SSID address settings. Note: the SSID address is the name of your Wireless Router’s name. For example, if the
address of the current Router (SSID) is: IHR810, then this SSID address should be typed in the tab of “SSID”.
5. WIFI password settings. Note: the password of the Wireless Router For example, if the WIFI’s current password
is:123456789, then this password should be typed in the tab of “WIFI password”.
6. Encryption type of WIFI SSID settings. Note: the encryption type of the
Wireless Router. For example, if the encryption type of the Router (SSID) is: WPA_TKIP_AES_PSK, then this information
should be selected in the tab of “SSID Encryption type”.
7. After filling the above information, click the “Setting All” option. The printer will “BEEP”. Next, restart the printer.
1
2
3
To Next Page
Loading...
