Chapter 5
IHR810 User Manual
www.impactbyhoneywell.com
13.
How to Configure IP Address for Ethernet Port.
Three ways to configure printer IP address:
a) Make configuration directly by IMPACT IHR810 Utility software.
( To download IMPACT IHR810 Utility software click here.)
b) Make configuration by sending the command codes;
c) Make configuration by browsing the WEB;
I. Make configuration directly by IMPACT IHR810 Utility software:
1. Printing Self-test to check the printer’s own IP address (factory default IP: 192.168.123.100); self-test method: turn off
the printer, then turn on the printer while holding down the FEED button, 2or 3 seconds later, release the FEED button
and a page with the title “ self test” will be printed out as shown by the picture below:
2. Confirm the printer IP address and then connect the printer to a computer through a hub, switch or cable directly (direct
interconnection method). (Note: the IP address may not be modified if the connection is established through a router)
Change the IP address by the IMPACT IHR810 Utility software is as follows:
2.1 Port selection------ NET
2.2 Printer Type ------ IHR810
2.3 Local IP ------ The computer IP address. Click "refresh" button, the computer IP address will be displayed. (Note: if the
refreshed IP address is 0.0.0.0, then it means the local IP conflicts with other devices, and make sure your IP address
is unique)
2.4 Printer IP ------the IP address on the self test page. (If the local IP and the printer IP are in the same network segment,
printing test can be conducted by clicking “connection test” button.
2.5 New IP address ------Enter the IP address you want to change to, click "Set New IP" button to complete the IP setting.
To Next Page
Loading...
