Honeywell IMPACT IHR810 - Chapter 12: IMPACT IHR810 Utility Tools; Utility Interface and Port Settings

Chapter 12
IMPACT IHR810 Utility Tools Instruction.
IHR810 User Manual
www.impactbyhoneywell.com
43.
To Download IMPACT IHR810 Utility Click Here.
1. Introduction of Main Interface:
1 2
3
5
6
7
8
9
10
11
12
13
14
4
1. Communication port selection:
Four options of printer communication interface: parallel port, serial port, USB port and Ethernet port.
2. Printer type :
Printer type: IHR 810.
3. Parallel port Settings (LPT Set):
Parallel port Settings---- be consistent with the computer communication parallel port number.
4. Serial port Settings (COM Set):
Serial port Settings----- set the serial port number, baud rate, flow control, etc.
5. Ethernet port Settings (NET Set):
Change the IP address of Ethernet port printer through Ethernet port Settings.
“Local IP”--- computer’s real IP address which can be added manually or by Clicking "refresh" button.
“Printer IP”---printer’s current IP address , its detailed information can be seen on self- test page.
“New IP address”--- the new IP address the printer’s IP address is to be changed to (printer’s IP address shall be in the
same network segment as the connected computer’s to realize intercommunication).
“New ID address”--- the new ID address the printer’s ID address is to be changed to (Printer’s ID address must be an only
address within a network). Ethernet port settings are operated by means of HUB and SWITCH, in case that the settings
can’t be changed by ROUTER, other means can be used.
“Auto Set IP” Used to search printers in the same LAN. The method of modifying the printer IP address across network
segments is as follows:
(1) Click the "Automatically Set IP" button to enter the setting interface.
(2) Click the "Find" function in the setting interface, and the MAC address of the connected printer will be displayed.
Double-click the MAC address of the printer to display the current IP address of the printer and other information.
After modifying the IP address, click the "Save" button. The printer buzzer will beep, indicating that the printer IP
address has been modified.