Honeywell LTE-L57V User Manual

LTE-L57V / LTE-L57C Cellular Communication Modules
Installation Guide
General Information
The LTE-L57V / LTE-L57C Cellular Communication Modules allow the LYNX Touch L5210 and L7000 controls to
communicate with the Central Station via the LTE cellular network.
See LYNX Touch Series Installation and Setup Guide (p/n 800-19974V1 or higher) for additional installation and
programming information.
Installing the Communication Module in the LYNX Touch Series Control
1. Install the provided FCC label (LTE-L57V: 800-23737
or LTE-L57C: 800-23737-1) on the control’s case
back (see diagram).
2. Release the LYNX Touch front case from the back
case by depressing the two locking tabs at the top of
the unit with the blade of a medium size screwdriver
(see diagram below).
3. Install the communication module into the LYNX
Touch control front case as shown. Ensure that the
connector board is properly seated into the
receptacle on the control.
4. Secure the module with the three provided screws.
5. Enable the communication module, configure alarm
reporting and module supervision and register the
device. Refer to the “Program the Radio” and
“Diagnostics” sections in the LYNX Touch Series
Installation & Setup Guide
(p/n 800-19974V1 or higher).
Typical FCC/IC Label Location (L5210 shown)
Installing the LTE-L57 Communication Module in the LYNX Touch (L5210 Shown)
Initial Power Up Note
Upon initial communicator
power up, a network
initialization sequence
begins and the LYNX control
displays the following:
SIM not yet provisioned.
Please wait. WARNING –
Do not reset the panel!!!
This sequence may take up
to 15 minutes. Do not reset
power during this
initialization time. After the
communicator has
completed network
initialization, subsequent
resets or power ups can take
up to 90 seconds.
Ê800-23726HŠ
800-23726 10/17 Rev B

Honeywell LTE-L57V Specifications

General

Brand	Honeywell
Model	LTE-L57V
Category	Control Unit
Language	English

Summary

LTE-L57V/LTE-L57C Cellular Communication Modules Installation Guide

General Information

Overview of LTE-L57V/LTE-L57C modules for LYNX Touch controls and central station communication.

Installing the Communication Module

Steps to physically install the cellular module into the LYNX Touch control, including securing the module.

Initial Power Up Procedure

Details the network initialization sequence upon initial communicator power up and potential waiting times.

Checking Signal Strength

Specifications and Notes

Device Specifications

Technical specifications including voltage, current, environmental limits, and antenna details.

External Antenna Requirements

Important notes and gain limits for professional installation of external cellular radio antennas.

Support and Warranty Information

Links for online support, documentation, warranty, and patent information.

Regulatory Statements

FCC Class B Statement

FCC requirements and statements regarding radio frequency energy and potential interference.

Industry Canada Class B Statement

Compliance statement for Industry Canada Class B digital apparatus.

FCC/IC Compliance

Device compliance with FCC Rules and Industry Canada license-exempt RSSs.

RF Exposure Warning

Warning regarding antenna installation distance from persons for RF exposure compliance.