Honeywell LCBS Connect

INSTALLATION INSTRUCTIONS
31-00084-01
LCBS Connect Wall Module
PRODUCT DESCRIPTION
The LCBS Connect Wall Module is a Sylk bus
communicating device which is exclusively compatible
with the LCBS Connect controller. It contains integral
temperature and humidity sensors to control any given
space’s comfort. This device enables local controller
configuration through an easy-to-use touch screen
interface with menu driven selections. The wall module
communicates and is powered by the Sylk bus, so no
additional wiring is necessary.
Dimensions
The TS120 consists of a back plate and a front cover which
contains a circuit board.
Fig. 1. Dimensions in in. (mm).
INSTALLATION
1. Read these instructions carefully. Failure to follow
them could damage the product or cause a hazard-
ous condition.
2. Check ratings given in instructions and on the prod-
uct to ensure the product is suitable for the applica-
tion.
3. Installer must be a trained, experienced service tech-
nician.
4. After installation is complete, check out product
operation as provided in these instructions.
MOUNTING
Mount the wall module on an inside wall approximately 48
in (1.2m) from the floor (or in the specified location) to
allow for exposure to the average zone temperature. Do
not mount the device on an outside wall, on a wall
containing water pipes or near air ducts. Avoid locations
that are exposed to discharge air from registers or
radiation from appliances, lights or the sun.
M36282
4-49/64
(121)
3-5/16
(84)
53/64
(21)

Honeywell LCBS Connect Specifications

General

Brand	Honeywell
Model	LCBS Connect
Category	Control Unit
Language	English

Summary

PRODUCT DESCRIPTION

Module Overview

Overview of the LCBS Connect Wall Module, its features, and Sylk bus compatibility.

Physical Dimensions

Details the physical size and form factor of the TS120 wall module.

INSTALLATION

Installation Steps Overview

General steps including reading instructions, checking ratings, installer qualifications, and post-installation checks.

Mounting Location Guidance

Specifies ideal and unsuitable locations for installing the wall module based on environmental factors.

Mounting Options

Describes how to mount the module on walls, conduit boxes, or outlet boxes.

WIRING

Preparing for Wiring

Instructions on how to separate the front cover from the subbase for wiring access.

Wiring Safety and Best Practices

Important cautions regarding electrical contact and conductor limits for terminal blocks.

Terminal Block Connection

Step-by-step guide on stripping wires and connecting them securely to the terminal block.

Daisy-Chaining Sylk Devices

Illustrates methods for connecting multiple Sylk devices in series or home-run configurations.

Sylk Bus Communication

Sylk Bus Wire Specifications

Details recommended wire types, gauge, and maximum distances for Sylk bus connections.

System Compatibility

LCBS Controller Pairing

Explains the specific one-to-one pairing requirement with the LCBS Connect controller.

SPECIFICATIONS

Operating and Shipping Conditions

Lists the operating temperature, shipping temperature, and relative humidity ranges for the device.

Related Parts

Compatible Sylk Sensors and Accessories

Table listing compatible Sylk sensors, their descriptions, and Sylk addresses.

Regulatory Approvals

FCC and Canadian Compliance

States compliance with FCC Part 15 and Canadian ICES-003 regulations.